How to do backside boardslide guide
The following trick tip will show you how to do bs boardslide
See video tutorial: How To Backside Boardslide
How to do frontside boardslide guide
The following trick tip will show you how to do frontside boardslide aka fs boardslide
The back and front foot should be set up as if you were going to be doing a backside 180 ollie.
See video tutorial: Rob Dyrdek Trick Tip: frontside boardslide
Email ThisBlogThis!Share to XShare to FacebookShare to Pinterest
Before you learn this trick you should know how to ollie. If you can frontside 180 it will help as well. In case you’re unfamiliar with how to figure out the difference between backside and frontside, remember that you’ll be approaching the rail with your back facing it.
The following trick tip will show you how to do bs boardslide
Set both of your feet up just as you would for an ollie. You really don’t need to change anything about this foot set up.
- Find a grindable rail, push a few times and get some speed. The faster you go, the longer you will be able to slide for. Ride backside up to the rail.
- Approach rail with proper speed, at a slight angle to help you into getting onto it. Pop the tail and slide your front foot up the board executing an ollie, while slightly turning your body and board 90 degrees putting you over the rail. This trick really starts once you get on the rail. Try to land the center of your board on the rail to make balance easier.
- To land from the grind, simply turn in the direction you want to land out of. If you want to get out before the end of the object, you’ll have to do a slight pop to get off.
See video tutorial: How To Backside Boardslide
How to do frontside boardslide guide
A boardslide is one the most basic slides in skateboarding and is the fundamental trick for learning more advanced tricks. Before you learn how to boardslide, you should know how to ollie while moving. Considering you’re going to have to rotate a bit to get into this trick, it si better if you have a consistent and comfortable backside 180.
Majority of people will say that a frontside boardslide is harder than a backside boardslide.
The following trick tip will show you how to do frontside boardslide aka fs boardslide
The back and front foot should be set up as if you were going to be doing a backside 180 ollie.
- Find a grindable rail or flat rail. Push a few times and get some speed. Ride frontside up to the rail so that your chest and toes are facing the rail.
- Approach rail with proper speed, at a slight angle to help you into getting onto it. Once you find you are close enough to the rail, pop your ollie and begin to guide your front trucks over the rail, trying to land your board as centered on it as possible.
- As you land on rail, your board should be perpendicular to the rail. Bend your knees slightly to balance yourself during the grind. Stay balanced through out the grind. Make sure not to lean too much either way.
- When you approach the end of the rail, turn your body 90 degrees back, and take your board with you.
See video tutorial: Rob Dyrdek Trick Tip: frontside boardslide
Email ThisBlogThis!Share to XShare to FacebookShare to Pinterest
0
comments
Subscribe to:
Post Comments (Atom)